Plumbers Frankfort KY
Get Estimate
Repair TipsLocal Guides

How to reset a garbage disposal that won't turn on


If your garbage disposal won't turn on, the fix is usually a 30-second reset. Here's exactly where the button is, why it trips, and when to call a Frankfort plumber.

FPlumbers Frankfort KY ·November 2026 ·9 min read
Four colorful trash bins against a rustic stone wall, an outdoor scene promoting recycling.

If your garbage disposal won't turn on, the fix is almost always a reset: press the red reset button on the bottom or back of the unit, then run cold water and flip the switch. That button pops when the motor overheats or the circuit overloads, and pushing it back in restores power in about 30 seconds. This guide walks you through the reset step by step, explains why it trips in the first place, and tells you when a Frankfort homeowner should stop fiddling and call a pro.

Why a garbage disposal won't turn on

A garbage disposal that won't turn on in Frankfort KY is usually dealing with one of four problems: a tripped internal overload, a tripped GFCI outlet, a jammed flywheel, or a burned-out motor. The reset button handles the first. The other three need a different approach, and mixing them up is how people end up replacing a disposal that was fine.

Here's what actually happens inside the unit. The motor draws 6 to 8 amps on a typical 1/2-horsepower model. When a fork handle, a chicken bone, or a wad of celery strings jams the flywheel, the motor stalls and pulls far more current than it should. A thermal overload switch inside the housing trips to protect the windings. That switch is the reset button. It is doing its job, not failing.

Older homes in Downtown Frankfort plumbers Frankfort KY often have the disposal sharing a circuit with a dishwasher or a kitchen light, which makes nuisance trips more common. If your disposal and another appliance die at the same time, check the breaker panel before you touch the disposal.

Where is the reset button on a garbage disposal?

The reset button on a garbage disposal is a small red or black square, about a quarter-inch wide, located on the bottom of the unit or on the lower back near the plumbing connections. On most InSinkErator and Waste King models sold in the U.S., it sits dead center on the underside of the housing. You have to reach under the sink to find it.

Shine a flashlight up at the bottom of the disposal. The button is recessed and usually red. If you see a small hole instead of a button, that's the reset on a different brand, and you'll need a flathead screwdriver or a pen to press it. Do not confuse it with the hex-socket wrench hole in the center, which is the manual crank for unjamming the flywheel.

If you cannot find the button or the unit is mounted so tightly against the cabinet floor that you can't reach it, that's a sign the installation was rushed. Our team sees this a lot in older South Frankfort plumbers Frankfort KY homes where a replacement disposal was swapped in without adjusting the drain line height.

How to reset a garbage disposal that won't turn on

To reset a garbage disposal that won't turn on, follow these steps in order. Skip one and you'll likely trip the button again within a minute.

  1. Turn the wall switch off. Leave it off for the entire process. Never reach into a disposal with the switch on.
  2. Check the outlet and breaker. If the disposal is plugged into a GFCI outlet under the sink, press the reset button on the outlet itself. Then check the breaker panel for a tripped circuit.
  3. Clear the sink. Remove any dishes, and use tongs or pliers, never your fingers, to pull out visible debris from the drain opening.
  4. Press the reset button. Push the red button on the bottom of the unit firmly until you feel it click. It should sit flush with the housing.
  5. Run cold water. Turn the faucet on cold and let it run for 10 to 15 seconds before flipping the switch.
  6. Turn the switch on. If the disposal hums and spins, you're done. If it hums without spinning, go to the next section. If it does nothing at all, the motor or the switch is the problem.

Cold water matters. Hot water softens grease and starches, which then congeal downstream and create the clogs that lead to drain cleaning Frankfort KY calls. Cold water keeps food particles solid so the disposal can grind them and the flow can carry them away.

What if the disposal hums but won't spin?

A humming disposal that won't spin is jammed, not dead. The motor is getting power but the flywheel is stuck. Turn the switch off immediately, because letting it hum for more than a few seconds will burn out the windings and turn a 10-minute fix into a replacement.

Here's the unjam procedure. With the switch off, insert the hex wrench that came with the disposal (usually a 1/4-inch Allen wrench) into the center hole on the bottom of the unit. Work it back and forth until the flywheel turns freely through a full rotation. If you don't have the wrench, a long screwdriver or the handle of a wooden spoon through the drain opening can work, but only with the power off.

Once it spins, remove the obstruction with pliers, press the reset button, and test with cold water running. If it jams again within a week, something is being fed into the disposal that it can't handle, or the flywheel is worn. That's when a garbage disposal repair Frankfort KY visit makes more sense than another round of DIY.

Common mistakes to avoid

Most failed reset attempts come down to a handful of avoidable errors. Here's what we see most often on service calls around Frankfort.

  • Pressing reset without clearing the jam. The button will trip again in seconds. Clear the flywheel first.
  • Reaching into the disposal. Even with the switch off, a jammed flywheel can release suddenly. Use tongs or pliers.
  • Running hot water during the reset. It accelerates grease buildup in the trap and the branch drain.
  • Ignoring a tripped GFCI. If the outlet under the sink is dead, the disposal has no power no matter how many times you press the reset button.
  • Grinding the wrong things. Coffee grounds, eggshells, potato peels, celery, and bones are the top five causes of jams we pull out of units in Frankfort Heights plumbers Frankfort KY homes.
  • Replacing the unit too early. A disposal that won't turn on is often a $0 reset, not a $250 replacement.

One more: don't pour chemical drain cleaner into a disposal that won't drain. It doesn't fix a jam, and it can damage the seals and the plastic housing over time.

When to call a professional

Call a professional when the disposal won't turn on after a reset and a GFCI check, when it trips the reset button repeatedly within a day, when you smell burning from the unit, or when water is leaking from the housing. Those four symptoms point to a failed motor, a bad switch, or a compromised seal, and none of them improve with another reset.

We handle emergency plumber Frankfort KY calls for disposals that are leaking into the cabinet or have tripped a breaker that won't stay on. We also replace units that are past their service life. A disposal typically lasts 8 to 12 years; if yours is older than that and has started tripping monthly, replacement is cheaper than repeated repairs.

If the reset button itself feels loose or won't stay pressed in, the overload switch has failed. That's a bench repair or a replacement, not a homeowner fix.

Frequently Asked Questions

How do I reset my garbage disposal in Frankfort KY?

Turn the wall switch off, then press the red reset button on the bottom or back of the unit until it clicks. Run cold water for 10 to 15 seconds, then turn the switch on. If it still won't run, check the GFCI outlet under the sink and the breaker panel.

Why won't my garbage disposal turn on in Frankfort Kentucky?

The most common cause is a tripped internal overload, which happens when the motor overheats or jams. The second most common is a tripped GFCI outlet. Less often, it's a failed motor, a bad wall switch, or a broken power cord. A reset and a GFCI check solve about 70% of no-power calls.

Where is the reset button on a garbage disposal in Frankfort?

On most models, it's a red or black button about a quarter-inch wide on the underside of the disposal housing, near the center. On some brands it's on the lower back near the drain connection. Shine a flashlight up from inside the cabinet to find it.

When should I call a plumber for garbage disposal repair in Frankfort KY?

Call when the disposal won't run after a reset and a GFCI check, trips the reset button more than once a week, smells like burning, or leaks from the housing. Those point to motor, switch, or seal failure. A typical repair runs $120 to $220 in 2026; replacement runs $250 to $450 installed.

Can I reset a garbage disposal with the switch on?

No. Always turn the wall switch off before reaching under the sink. The flywheel can release suddenly when the jam clears, and the motor can start if the switch is live. Turn the switch off, reset, then test with cold water running.

Get help with plumbers Frankfort KY in Frankfort

If your disposal still won't turn on after a reset, or it's humming, leaking, or tripping the breaker, our team can diagnose it the same day. We work on every major brand and stock the common replacement units so most jobs are done in one visit.

Call +18312931204 to schedule service with plumbers Frankfort KY.

Tagged with

#garbage disposal#reset button#Frankfort KY#kitchen plumbing#diy repair

Common Questions

How do I reset my garbage disposal in Frankfort KY?
Turn the wall switch off, then press the red reset button on the bottom or back of the unit until it clicks. Run cold water for 10 to 15 seconds, then turn the switch on. If it still won't run, check the GFCI outlet under the sink and the breaker panel.
Why won't my garbage disposal turn on in Frankfort Kentucky?
The most common cause is a tripped internal overload, which happens when the motor overheats or jams. The second most common is a tripped GFCI outlet. Less often, it's a failed motor, a bad wall switch, or a broken power cord. A reset and a GFCI check solve about 70% of no-power calls.
Where is the reset button on a garbage disposal in Frankfort?
On most models, it's a red or black button about a quarter-inch wide on the underside of the disposal housing, near the center. On some brands it's on the lower back near the drain connection. Shine a flashlight up from inside the cabinet to find it.
When should I call a plumber for garbage disposal repair in Frankfort KY?
Call when the disposal won't run after a reset and a GFCI check, trips the reset button more than once a week, smells like burning, or leaks from the housing. Those point to motor, switch, or seal failure. A typical repair runs $120 to $220 in 2026; replacement runs $250 to $450 installed.
Can I reset a garbage disposal with the switch on?
No. Always turn the wall switch off before reaching under the sink. The flywheel can release suddenly when the jam clears, and the motor can start if the switch is live. Turn the switch off, reset, then test with cold water running.

Need plumbers Frankfort KY to reset or repair your disposal in Frankfort?

We diagnose disposal problems the same day and carry the common replacement units on the truck. Call us and we'll get your kitchen back to normal.

Call Now: (831) 293-1204 Send a Message
Call Now: (831) 293-1204 Get Quote
Call Quote