New Water Heater
We supply Rheem, Bradford White, or A.O. Smith tanks in the size you need, or a Rinnai or Navien tankless unit if you are upgrading. The unit comes with the manufacturer warranty, and we register it for you.
Every install includes the basics that keep your unit safe and your warranty valid. Here is what comes standard, plus a few add-ons we can quote if your setup needs them.
We supply Rheem, Bradford White, or A.O. Smith tanks in the size you need, or a Rinnai or Navien tankless unit if you are upgrading. The unit comes with the manufacturer warranty, and we register it for you.
We install new flex connectors or copper pipe, a T&P relief valve and line, and a drip leg on gas units. We follow the Kentucky Plumbing Code and Uniform Plumbing Code so the job passes inspection.
We drain and remove the old tank and take it with us. No extra charge, no tank sitting at the curb for weeks. We also clean up any sediment or water that spilled during the swap.
We test for gas leaks, check the venting draft, and confirm the T&P relief line is routed to a safe drain. We set the temperature to 120 degrees and show you how to shut the unit down in an emergency.
When a permit is required, we pull it and meet the inspector. You do not have to chase paperwork or schedule the inspection. We handle it as part of the job.
Water heater installation Frankfort KY is the licensed removal of your old unit and the code-correct hookup of a new gas, electric, or tankless water heater, including the tank, venting, supply lines, and safety controls. We start by shutting off the gas or breaker, draining the old tank, and checking the shutoff valve and venting for corrosion. Then we set the new unit, solder or crimp the connections, and fill and test the system before we call the job done.
Most Frankfort homes we see are running 10- to 15-year-old tanks that were never flushed. Sediment builds up, the anode rod wears out, and the tank starts weeping at the seams. If you are searching for water heater installation near me Frankfort KY because your basement floor is wet, we can usually replace the unit the same day. We also handle Frankfort KY water heater replacement for homeowners upgrading to a larger tank or a tankless system.
We keep the job predictable. Here is the five-step process we follow on every water heater installation in Frankfort, from the first call to the final test.
Schedule
Call or book online — a real human picks up and confirms a 2-hour arrival window.
Diagnose
Licensed tech inspects on-site, then walks you through the cause and your options.
Fix
The job is completed to code and done right the first time — no shortcuts, no surprises.
Guarantee
Every job backed by a written workmanship warranty — and we stand behind it.
Pipe Wrench and Tube Cutter
Used to break loose old fittings and cut copper pipe cleanly. A clean cut means a proper solder joint or crimp connection that will not leak.
Soldering Torch and PEX Crimping Tool
We solder copper pipe or crimp PEX tubing depending on your home's setup. Both methods meet code when done right, and we choose the one that fits your existing lines.
Pressure Gauge
We check your home's water pressure before and after the install. High pressure can shorten a tank's life, so we note it and recommend a regulator if needed.
Leak Detection Equipment
Used to check every connection after the tank is filled. We also use it to trace hidden leaks if the old unit caused water damage behind a wall.
Drain Snake and Pipe Camera Inspection System
If sediment from the old tank clogs a drain or fixture, we clear it. The camera lets us confirm the line is clear before we leave.
Kentucky Plumbing Code and Uniform Plumbing Code
We follow both on every install, including venting, T&P relief, and gas line sizing. That keeps your job code-correct and your warranty valid.
Anode Rod Inspection
We check the anode rod on every tank we touch. If it is more than half gone, we replace it. This simple step can add years to a tank's life.
Temperature and Pressure Relief Testing
We test the T&P valve and route the relief line to a safe drain. A failed valve is a safety hazard, and we will not leave a job without confirming it works.
01
What we do: We replace it before it fails completely. A planned swap costs less than an emergency call after the tank floods your basement.
→ You get a new unit with a warranty and avoid water damage. Most jobs are done in a single afternoon.
02
What we do: We size the new water heater for the added demand. That might mean a larger tank or a tankless unit with a higher flow rate.
→ Hot water keeps up with the new fixtures, and you do not have to replace the heater again in two years.
03
What we do: We inspect the unit, document its condition, and quote a replacement. If you are closing soon, we can schedule the install around your closing date.
→ You move in with a working water heater and a clear record of the install for your files.
04
What we do: We check the gas line size and venting, then install a Rinnai or Navien unit sized for your home. We handle the permit and inspection.
→ You gain floor space and endless hot water, and the unit can last 20 years with annual flushing.
Frankfort homes range from 1920s bungalows near Downtown to newer builds out on Versailles Road, and the water heater setup changes with the house. Older homes often have galvanized or copper lines, tight utility closets, and venting that does not meet current code. Newer homes may have PEX tubing and a dedicated heater closet. We check the shutoff valve, venting, and gas line on every job because a weak point there can fail within a year. Winter is our busiest season for frozen pipes and failed tanks, so we keep common sizes on the truck. If you need Frankfort KY water heater replacement before the holidays, call early. We serve ZIP codes 40601, 40603, 40618, 40619, 40620, and 40621 across Franklin County.
Downtown Frankfort
Many homes here are 80 to 100 years old with tight utility spaces. We measure carefully and use flexible connectors to fit a new tank without cutting door frames.
South Frankfort
A mix of older homes and renovations. We often find undersized gas lines on upgrades to tankless, so we check the meter and line size first.
Frankfort Heights
Basements are common here, which makes for easier access. We still check for slab leaks and water damage before setting a new tank.
Versailles Road
Newer construction with PEX tubing and dedicated heater closets. Installs are usually straightforward, and we can often do them same-day.
Cold winters and frozen pipes
Frozen pipes can burst and damage a water heater's supply lines. We insulate exposed lines and check for freeze risk during every winter install.
Older homes with galvanized pipe
Galvanized lines corrode from the inside and restrict flow. We check the water pressure and recommend replacing the section between the shutoff and the heater if it is badly rusted.
Hard water in Franklin County
Hard water shortens tank life by building sediment. We flush the tank and check the anode rod, and we can recommend a water softener if the buildup is severe.
Most water heater calls start with one of these four problems. If any of them sound familiar, a replacement is usually the cheaper fix.
Problem
A leaking tank will not heal itself. Water can damage your floor, drywall, and stored belongings, and the leak can worsen without warning.
Our Fix
We shut off the water and gas, drain the tank, and install a new unit the same day when possible. We also check the floor and nearby framing for water damage before we set the new tank.
Problem
A failed heating element or a tank full of sediment means cold showers and higher energy bills. It usually gets worse over time.
Our Fix
We test the elements and thermostat first. If the tank is over 10 years old or the sediment is severe, we recommend replacement. A new 40- or 50-gallon tank restores hot water the same day.
Problem
Rust-colored water usually means the tank lining is failing. A rotten-egg smell often means the anode rod is spent, and the tank may be close behind.
Our Fix
We check the anode rod and flush the tank. If the lining is compromised, we replace the unit. A new tank with a fresh anode rod fixes the water quality and protects the warranty.
Problem
A 30-gallon tank in a four-person home runs out of hot water every morning. It also works harder and wears out faster.
Our Fix
We measure your fixtures and peak demand, then recommend the right size. Upgrading to a 50-gallon tank or a tankless system solves the shortage and can lower standby heat loss.
A water heater is only as good as the install behind it. These are the outcomes our Frankfort customers notice most after we swap out an old unit.
Lower Energy Bills
A new high-efficiency tank or tankless unit can cut water heating costs by 15 to 30 percent compared to a sediment-filled 12-year-old tank. We size the unit to your household so it runs less and lasts longer.
Hot Water That Lasts
We match tank size to your bathrooms and appliances. A family of four in Frankfort usually needs a 40 gallon water heater installation Frankfort KY or a 50-gallon unit, and we will tell you which one fits your space and demand.
Code-Correct Safety
Gas units need proper venting, a drip leg, and a T&P relief line routed to a safe drain. We follow the Kentucky Plumbing Code and Uniform Plumbing Code on every install, so your unit passes inspection and your family stays safe.
Fewer Emergency Calls
A tank installed with a new shutoff valve, fresh flex connectors, and a properly seated anode rod is far less likely to leak or fail. We also label the gas valve and breaker so the next plumber, or you, can shut it down fast.
Typical 2026 pricing in Frankfort runs $1,200 to $2,500 for a standard tank replacement and $2,800 to $4,500 for a tankless install. The unit itself is about half the cost; labor, permits, and code upgrades make up the rest. A straightforward swap in a basement with good access sits at the low end. A tight closet, a seized shutoff valve, or a needed venting repair moves it higher. We quote a flat price before we start, so you know the full cost of water heater replacement cost Frankfort, Kentucky before we begin.
Typical Investment Range
$1,200 - $4,500 depending on unit type and scope
A new water heater lasts 10 to 12 years for a tank and 20 or more for tankless. Spread over that life, a proper install costs less per year than repeated repairs on an old unit, and it protects your floors and belongings from leaks.
What changes the price
Tank Size and Type
A 40-gallon tank costs less than a 50- or 75-gallon unit. Tankless units cost more upfront but last longer and can lower energy bills over time.
Fuel Type
Gas units need venting and a gas line check, which adds labor. Electric units are simpler to install but may need a dedicated circuit if one is not already there.
Location and Access
A basement or garage with wide access is quick to work in. A tight closet, attic, or crawlspace adds time and sometimes requires helper labor.
Code Upgrades
If the shutoff valve, venting, or T&P relief line is not up to code, we fix it during the install. That adds cost but keeps the job safe and inspection-ready.
Permit Fees
Frankfort requires a permit for water heater replacement in most cases. The fee is part of the quoted price, and we handle the paperwork and inspection.
Google ★★★★★4.9
They replaced our leaking water heater the same day we called. The plumber was on time, explained the price upfront, and cleaned up after himself. I would call them again for any plumbing job.
Yelp ★★★★★4.8
We had a tankless unit installed and the crew was professional and tidy. They walked us through the maintenance and answered every question. The hot water has been perfect since.
BBB A+
Fair pricing and honest advice. They told us we could repair our old unit instead of replacing it, but we chose to upgrade. No pressure either way. That is rare.
Our team holds Kentucky Master Plumber and Journeyman Plumber licenses and works to the Kentucky Plumbing Code on every job. We have installed and replaced hundreds of tanks across Franklin County, from older homes near Downtown Frankfort to newer builds out on Versailles Road. We carry backflow prevention certification and follow OSHA safety compliance on every site. When we open a wall or crawlspace, we also work to EPA Lead-Safe Certification standards on pre-1978 homes.
Real experiences from customers who chose our Water Heater Installation services.
“Our 14-year-old water heater started leaking on a Friday morning. I called and they had a new 50-gallon Rheem in by 3 p.m. The plumber showed me the old anode rod, which was completely gone. He also replaced the shutoff valve and hauled the old tank away. Clean, fast, and the price was exactly what he quoted on the phone.”
Dana R.
Homeowner, South Frankfort
“We switched from a tank to a Rinnai tankless unit. The crew ran a new gas line and venting and had hot water back the same day. They walked me through the temperature settings and showed me how to flush the unit once a year. It cost more than a tank, but we have not run out of hot water since.”
Marcus T.
Homeowner, Frankfort Heights
“The old tank in our 1920s house was in a tight closet. Two other companies said they would have to cut the door frame. This team measured carefully and got a 40-gallon unit in without damage. They also checked the venting, which was not up to code, and fixed it. I appreciated that they did not cut corners.”
Ellen K.
Homeowner, Downtown Frankfort
Real answers to the questions we hear most often from local homeowners and property managers.
A water heater leak at 2 a.m. is an emergency. We shut off the water, stop the damage, and can often replace the unit the same day. Call us before the water reaches your finished basement.
View Emergency PlumbingSediment from an old tank can clog aerators and fixtures. If your drains are slow after an install, we can clear them with a drain snake or hydro jetting machine and check the line with a pipe camera inspection system.
View Drain CleaningNot every problem needs a new tank. If your unit is under 10 years old and the issue is a failed thermocouple, heating element, or anode rod, we can repair it and save you the cost of a full replacement.
View Water Heater RepairTankless units from Rinnai and Navien save space and deliver endless hot water. We handle the gas line upgrade, venting, and water line connections. It is a bigger job than a tank swap, but the result lasts 20 years or more.
View Tankless Water Heater InstallationIf you see water near the heater but cannot find the source, we use leak detection equipment and a pressure gauge to trace it. Catching a slab leak or pinhole in copper pipe early saves thousands in water damage.
View Leak DetectionA burst pipe can flood a basement fast. We locate the break, shut off the water, and repair or replace the section. If the burst is near your water heater, we can handle both jobs in one visit.
View Burst Pipe RepairCall us any time, day or night. For non-emergency work, we schedule same-day and next-day appointments across Frankfort. Tell us what's going on and we'll give you a time window and a price range before we head out. You can also email us, but for anything urgent, pick up the phone.
Phone
(831) 293-1204Address
1098 S Broadway #120, Lexington, KY 40504
Hours
Mon–Fri: 7AM – 7PM
Sat: 8AM – 4PM
Sun: Emergency Only
24/7 Emergency Available